ESC for Electric Paramotor Power System PM-UH200

1.SOC(%)
SOC is defined as the percentage of the battery remaining charge to the current maximum capacity. Before use it, you need to check whether the set full capacity and number of battery cells are both correct. When the battery is fully charged, please press the “Up” button to reset the power to 100%; and the device will automatically recognize it as full capacity when it is turnedon.
The displayed remaining capacity is for reference only. Due to the limitation of sampling accuracy, product measurement may deviate from the actual value. Please don’t rely too much on it. In addition, when the remaining capacity reaches the set prompt value, the LED light flashes and the remaining capacity percentage flashes at the same time.

2. Flight altitude
Before using it, please press the “Up” button and the “Down” button simultaneously for a long time to clear the current flight altitude and calibrate it. When the main interface of PPG Controller displays an altitude lower than 1km, its display unit is m. Such as “999m”. When the flight altitude is greater than 1km, it only displays k and ignores the unit “m”, such as “1.99k”. Under normal use, its accuracy is 1 m. During usage, please keep the vents on the back cover open for ventilation and heat dissipation.

3.CAN connection status
It displays the CAN connection status. When it displays “CAN”, it means the CAN bus is connected at this time. When it displays “CAN” and the icon fashes, it means that the CAN is in a disconnected state and the indicator light will flash.

4. Motor temperature and ESC temperature:
There is a temperature senso rinside the ESc that can direlcly display the ESC temperature.However, If you need to display the motlor temperalure,you need to correctly instalthe temperatur sensor on the motor according to the user manual of ESC. When the temperature of the ESC and motor reaches the set high temperature protecion threshold,it will trigger the high temperalure protection, high temperalure protetcion will force the made to be converted to economy mode at this ime. and it will not allow switching modes until the high temperature protection ends.
At this time.the LED indicator light flashes, and at the same time, the corresponding temperature part aiso flashes to facilitate the user to find the cause of the fault faster.The high temperature protection will not end until the temperature drops o the set high temperature protection threshold (minus 25 C) Then, after returning to normal mode ,you can switch to “MAX” mode:

5.Mode display
The mode can be set to two modes, “MAX” mode and “ECO” mode. lf it displays “ECO/MAX” ,it means economic mode,lf it displays “ECO/MAX”.it means powerful mode. When the “Down” button is long pressed, the mode will switch, During the switching process, the total throttle percentage increases or decreases by 1% every 0.1S; it can switch modes during fall protection, high temperature protecton.and low voltage protection.

6.Fall protection
The product is normally placed vertically at 90 degrees. When its angle is within the setting range.it is judaed as normal. if its angle exceeds the setting range.it will be considered a fall. The default value of pitch angle is 60-135 (60 is a fixed value and cannot be set), The default value of roll angle is-45~45, Within this value. the fall prolecion throttle is immediately cleared and the LED fashes. At the same time,the mode display position changes to” !”, and fiashes, indicaing fall protection. Mode operation cannot be switched at this time. When the angle returns to the set degree minus 15 dearees for 1S (when it is pitch, it is 60 dearees to the set maximum value minus 15 dearees).it will return to normal. At this time, the total throttle percentage is increased that is, it increases by 1% every 0.1S to the total throttle percentage of the original mode.

For more information, please refer to the instruction manual.